These trisliding 3 panel gates were handmade by our team of expert blacksmiths.
Telescopic driveway gate uk.
This project presented a unique challenge.
Two centre meeting triple leaf sliding driveway gates utilising hardware from fac srl.
Telescopic gates work by individual sections of a gate overlapping each other as the gate opens.
Automatic telescopic driveway gates.
These are ideal for properties with short driveways that are limited on entrance space.
A telescopic gate with a level top that opens down hill has guide rails dropping down as the gate opens and if the tops of both gate panels are at the same height when closed the guide rails can be fitted to the top of each panel.
A telescopic gate has the advantage that it takes up less space compared to other sliding gates when in the open position.
No room for a traditional sliding gate.
Our 2 leaf telescopic gate kits are suitable for standard cantilever gates and are available for openings from 4m up to a maximum of 11 4m.
We can apply the telescopic gate system to basically any design.
Telescopic gates basically allow twice the opening width into half the space.
Telescopic sliding gates use individual panels that overlap each other as the gate opens.
Telescopic gates can be either manual or automatic access controlled.
With these gates we can achieve a wider driveway opening within your overall.
Fabricated by forging ahead fabrication auckland nz.
By having 2 leaves simultaneously working together standard telescopic gate kits allow for a much smaller space adjacent to the opening of the gate.
Our telescopic gates systems have been created to allow a sliding gate to take up less space to the side of the opening by having 2 leaves simultaneously working together.
Regular telescopic gate span 2 5 m to 5 m 8 ft to 16 ft for a single car driveway or two car parking all our telescopic metal gates are made to order we don t keep stock.
The driveway opening was close to 6m wide but there was insufficient room beside the gate for a standard sliding gate to roll back into a traditional sliding gate would need a width equal to or greater than that of the opening to one side to take the gate in the open position.
For example if you had a four metre opening but only two and a half metres of run off area with a standard sliding gate there is simply no way to install in this area.
Composite wood wrought iron and so on.
The amount each guide rail drops with a two panel telescopic gate is half.
